Pit or Surface Mounted SBPMC Versions
- The SBP/MC weighbridge is available in surface or pit mounted versions.
- Surface mounted height: 400mm
- Pit mounted minimum foundation depth: 500mm (recommended)
- The SBP/MC is available in pour on site, or pre-cast/stressed versions
Strength: The SBP/MC is designed in accordance with BS 5400 to carry vehicles covered by the Motor Vehicles (Construction and Use)
Pre Cast Weighbridge
Although this bridge is usually cast on site we have manufacture it as a precast weighbridge if required.
Paint Finish & Steelwork
Paint finish on all steelwork: All steelwork is shot-blasted to remove mill scale and surface imperfections. The steel work is then coated in a high-performance epoxy primer (50 microns) followed by a specialized hard coat alkyl enamel finish (75 microns).
Inspection plates: Each weighbridge has two sets of inspection plates (one set at each end). These plates are for access to the pit for cleaning purposes and for maintenance of load cells. The end plates are 465mm deep and come in a 1,250mm & 1,7500mm set (to make up the 3,000mm width). The two and three section weighbridges also have 270mm x 3,000mm middle plates for access to load cells
Load Cells & Cable Protection
Load Cells: All load cells supplied with the SBP/MC are of the canister type. All are stainless steel. Digital and analog load cells are available. All load cells are approved for trade and are EC compliant.
Cable Protection: All SBP/MC cables are run through conduit for protection and are connected at a central stainless steel junction box.